PRVT-MPLS-IF-MIB
B.A.T.M. Advance TechnologiesThis module includes configuration parameters for MPLS and RSVP interface specific parameters.
snmptranslate -m PRVT-MPLS-IF-MIB -Tpsnmpwalk -v2c -c <community> -m PRVT-MPLS-IF-MIB <host> 1.3.6.1.4.1.738.1.6.5.6Imports
| IF-MIB | ifEntry, ifIndex |
|---|---|
| INET-ADDRESS-MIB | InetAddress |
| PRVT-CR-LDP-MIB | mpls |
| SNMPv2-CONF | MODULE-COMPLIANCE, NOTIFICATION-GROUP |
| SNMPv2-SMI | Bits, Integer32, IpAddress, MODULE-IDENTITY, MibIdentifier, OBJECT-IDENTITY, OBJECT-TYPE, TimeTicks, Unsigned32, iso |
| SNMPv2-TC | DisplayString, PhysAddress, RowStatus, TEXTUAL-CONVENTION, TruthValue |
OID tree
| Name | OID | Type | Access | Status |
|---|---|---|---|---|
| IprvtMPLSIfMib | 1.3.6.1.4.1.738.1.6.5.6 | |||
identity This module includes configuration parameters for MPLS and RSVP interface specific parameters. | ||||
| NprvtMPLSIfaceObjs | 1.3.6.1.4.1.738.1.6.5.6.1 | |||
| TprvtMplsIfaceTable | 1.3.6.1.4.1.738.1.6.5.6.1.1 | NA | ||
table · not-accessible · current This table contains object for configuring MPLS and LDP interface specific parameters. | ||||
| RprvtMplsIfaceEntry | 1.3.6.1.4.1.738.1.6.5.6.1.1.1 | NA | ||
| CifaceMplsEnable | 1.3.6.1.4.1.738.1.6.5.6.1.1.1.1 | TruthValue | RW | |
column · TruthValue · read-write · current Enable or disable MPLS on this interface. | ||||
| CifaceMplsPHPEnable | 1.3.6.1.4.1.738.1.6.5.6.1.1.1.2 | TruthValue | RW | |
column · TruthValue · read-write · current Enable or disable Penultimate Hop Popping on this interface. | ||||
| CifaceMplsIngressLblRangeLow | 1.3.6.1.4.1.738.1.6.5.6.1.1.1.3 | Integer32 (32768..131071) | RW | |
column · Integer32 (32768..131071) · read-write · current This is the lower border of the Ingress Lable Range for this interface. | ||||
| CifaceMplsIngressLblRangeHigh | 1.3.6.1.4.1.738.1.6.5.6.1.1.1.4 | Integer32 (32768..131071) | RW | |
column · Integer32 (32768..131071) · read-write · current This is the higher border of the Ingress Lable Range for this interface. | ||||
| CifaceMplsEgressLblRangeLow | 1.3.6.1.4.1.738.1.6.5.6.1.1.1.5 | Integer32 (32768..131071) | RW | |
column · Integer32 (32768..131071) · read-write · current This is the lower border of the Egress Lable Range for this interface. | ||||
| CifaceMplsEgressLblRangeHigh | 1.3.6.1.4.1.738.1.6.5.6.1.1.1.6 | Integer32 (32768..131071) | RW | |
column · Integer32 (32768..131071) · read-write · current This is the higher border of the Egress Lable Range for this interface. | ||||
| CifaceMplsLdpHelloHoldTimer | 1.3.6.1.4.1.738.1.6.5.6.1.1.1.7 | Integer32 (1..65535) | RW | |
column · Integer32 (1..65535) · read-write · current LDP Hello Hold Time. | ||||
| CifaceMplsLdpKeepaliveHoldTimer | 1.3.6.1.4.1.738.1.6.5.6.1.1.1.8 | Integer32 (1..65535) | RW | |
column · Integer32 (1..65535) · read-write · current LDP Hello Keep-alive Time. | ||||
| CifaceMplsLdpUseGlobalLabelSpace | 1.3.6.1.4.1.738.1.6.5.6.1.1.1.9 | TruthValue | RW | |
column · TruthValue · read-write · current Default value is true and correct value is true. | ||||
| TprvtRsvpIfaceTable | 1.3.6.1.4.1.738.1.6.5.6.1.2 | NA | ||
table · not-accessible · current This table contains object for configuring RSVP interface specific parameters. | ||||
| RprvtRsvpIfaceEntry | 1.3.6.1.4.1.738.1.6.5.6.1.2.1 | NA | ||
| CifaceRsvpRefreshInterval | 1.3.6.1.4.1.738.1.6.5.6.1.2.1.1 | Integer32 | RW | |
column · Integer32 · read-write · current The RSVP value, R, which is used to set the average interval between refresh path and resv messages. | ||||
| CifaceRsvpRefreshMultiple | 1.3.6.1.4.1.738.1.6.5.6.1.2.1.2 | Integer32 | RW | |
column · Integer32 · read-write · current The RSVP value, K, which is the number of unresponded Path or Resv refresh attempts which must be made, spaced by the refresh interval before the state is deemed to have timed out. | ||||
| CifaceRsvpSlewNumerator | 1.3.6.1.4.1.738.1.6.5.6.1.2.1.3 | Integer32 (1..214783647) | RW | |
column · Integer32 (1..214783647) · read-write · current The numerator of the fraction, SlewMax, which is the maximum allowable increase in the refresh interval, R, to prevent state timeout while changing R. R is increased by this fraction until it reaches the new desired value. | ||||
| CifaceRsvpSlewDenom | 1.3.6.1.4.1.738.1.6.5.6.1.2.1.4 | Integer32 (1..214783647) | RW | |
column · Integer32 (1..214783647) · read-write · current The denominator of the fraction, SlewMax, which is the maximum allowable increase in the refresh interval, R, to prevent state timeout while changing R. R is increased by this fraction until it reaches the new desired value. | ||||
| CifaceRsvpBlockadeMultiple | 1.3.6.1.4.1.738.1.6.5.6.1.2.1.5 | Integer32 (1..214783647) | RW | |
column · Integer32 (1..214783647) · read-write · current The RSVP value, Kb, which is the number of refresh timeout periods after which blockade state is deleted. | ||||
| CifaceRsvpNotifyRRDecay | 1.3.6.1.4.1.738.1.6.5.6.1.2.1.6 | Integer32 (0..100) | RW | |
column · Integer32 (0..100) · read-write · current The percentage increase in the rapid retransmission interval for each consecutive unacknowledged RSVP Notify message. A value of 0 indicates a constant retransmission rate. | ||||
| CifaceRsvpNotifyRRInterval | 1.3.6.1.4.1.738.1.6.5.6.1.2.1.7 | Integer32 (1..214783647) | RW | |
column · Integer32 (1..214783647) · read-write · current The interval in milliseconds before a Notify message is first resent if no acknowledgement is received. | ||||
| CifaceRsvpNotifyRRLimit | 1.3.6.1.4.1.738.1.6.5.6.1.2.1.8 | Integer32 (1..214783647) | RW | |
column · Integer32 (1..214783647) · read-write · current The maximum number of times a Notify message is resent if no acknowledgement is received. | ||||
| CifaceRsvpHelloInterval | 1.3.6.1.4.1.738.1.6.5.6.1.2.1.9 | Integer32 | RW | |
column · Integer32 · read-write · current The interval between sending consecutive Hello messages. | ||||
| CifaceRsvpHelloDecay | 1.3.6.1.4.1.738.1.6.5.6.1.2.1.10 | Integer32 (0..100) | RW | |
column · Integer32 (0..100) · read-write · current Percentage increase of hello interval after each Hello message sent when the hello session with the neighbor has timed out. | ||||
| CifaceRsvpHelloTolerance | 1.3.6.1.4.1.738.1.6.5.6.1.2.1.11 | Unsigned32 | RW | |
column · Unsigned32 · read-write · current The number of hello periods which may pass without receiving a successful Hello message from a partner before the Hello session times out. | ||||
| CifaceRsvpHelloPersist | 1.3.6.1.4.1.738.1.6.5.6.1.2.1.12 | Unsigned32 | RW | |
column · Unsigned32 · read-write · current The number of hello periods which may pass after the Hello session times out before Hello messages cease. | ||||
| CifaceRsvpHelloTTL | 1.3.6.1.4.1.738.1.6.5.6.1.2.1.13 | Integer32 (1..255) | RW | |
column · Integer32 (1..255) · read-write · current The Time To Live that will be set in the IP header of all Hello packets sent to the neighbor associated with this interface. | ||||
| NprvtMPLSRouteObjs | 1.3.6.1.4.1.738.1.6.5.6.2 | |||
| TprvtMplsRouteProtocolTable | 1.3.6.1.4.1.738.1.6.5.6.2.1 | NA | ||
table · not-accessible · current This table contains for configuring the egress and ingress routes for LDP label packets. It supports all CLI route types - bgp, isis, ospf, rip, static, kernel and connected. | ||||
| RprvtMplsRouteProtocolEntry | 1.3.6.1.4.1.738.1.6.5.6.2.1.1 | NA | ||
row · not-accessible · current An entry in the table represents the configuration of a particular route type for ingress or egress. | ||||
| CprvtMplsRouteDirection | 1.3.6.1.4.1.738.1.6.5.6.2.1.1.1 | INTEGER | RO | |
column · INTEGER · read-only · current The direction of the route that will be used to receive or send LDP packets.
| ||||
| CprvtMplsRouteType | 1.3.6.1.4.1.738.1.6.5.6.2.1.1.2 | INTEGER | RO | |
column · INTEGER · read-only · current The type of the route which will be used to send or receive LDP packets.
| ||||
| CprvtMplsRouteRowStatus | 1.3.6.1.4.1.738.1.6.5.6.2.1.1.3 | RowStatus | RC | |
column · RowStatus · read-create · current This object is used to create an entry in the table. Only createAndGo(4) should be used. | ||||
| TprvtMplsRouteAddressTable | 1.3.6.1.4.1.738.1.6.5.6.2.2 | NA | ||
table · not-accessible · current This table contains for configuring the egress and ingress routes for LDP label packets. It supports all CLI route types - bgp, isis, ospf, rip, static, kernel and connected. | ||||
| RprvtMplsRouteAddressEntry | 1.3.6.1.4.1.738.1.6.5.6.2.2.1 | NA | ||
row · not-accessible · current An entry in the table represents the configuration of a particular route type for ingress or egress. | ||||
| CprvtMplsAddressDirection | 1.3.6.1.4.1.738.1.6.5.6.2.2.1.1 | INTEGER | RO | |
column · INTEGER · read-only · current The direction of the route that will be used to receive or send LDP packets.
| ||||
| CprvtMplsAddressIPAddr | 1.3.6.1.4.1.738.1.6.5.6.2.2.1.2 | InetAddress | RO | |
column · InetAddress · read-only · current The IP address of the route that will be used to send or receive LDP packets. | ||||
| CprvtMplsAddressMask | 1.3.6.1.4.1.738.1.6.5.6.2.2.1.3 | Integer32 (0..32) | RO | |
column · Integer32 (0..32) · read-only · current The mask for the IP address of the route that will be used to send or receive LDP packets. | ||||
| CprvtMplsAddressRowStatus | 1.3.6.1.4.1.738.1.6.5.6.2.2.1.4 | RowStatus | RC | |
column · RowStatus · read-create · current This object is used to create an entry in the table. Only createAndGo(4) should be used. | ||||