CISCOSB-BRGMACSWITCH-MIB
ciscoSystemsThis private MIB module defines Switching Parameters private MIBs.
snmptranslate -m CISCOSB-BRGMACSWITCH-MIB -Tpsnmpwalk -v2c -c <community> -m CISCOSB-BRGMACSWITCH-MIB <host> 1.3.6.1.4.1.9.6.1.101.50Imports
| CISCOSB-MIB | switch001 |
|---|---|
| SNMPv2-CONF | MODULE-COMPLIANCE, NOTIFICATION-GROUP |
| SNMPv2-SMI | Bits, Integer32, IpAddress, MODULE-IDENTITY, MibIdentifier, OBJECT-IDENTITY, OBJECT-TYPE, TimeTicks, Unsigned32, iso |
| SNMPv2-TC | DisplayString, PhysAddress, TEXTUAL-CONVENTION, TruthValue |
OID tree
| Name | OID | Type | Access | Status |
|---|---|---|---|---|
| IrlBrgMacSwitch | 1.3.6.1.4.1.9.6.1.101.50 | |||
identity This private MIB module defines Switching Parameters private MIBs. | ||||
| SrlBrgMacSwVersion | 1.3.6.1.4.1.9.6.1.101.50.1 | INTEGER | RO | |
scalar · INTEGER · read-only · current MIB's version, the current version is 2. | ||||
| SrlBrgMacSwMaxTableNumber | 1.3.6.1.4.1.9.6.1.101.50.2 | INTEGER | RO | |
scalar · INTEGER · read-only · current Maximum number of MAC Tables supported by the device. | ||||
| SrlBrgMacSwDynamicTables | 1.3.6.1.4.1.9.6.1.101.50.3 | INTEGER | RO | |
scalar · INTEGER · read-only · current Specifies whether the device supports port dynamic MAC tables.
| ||||
| SrlBrgMacSwOldEntryDeleteMode | 1.3.6.1.4.1.9.6.1.101.50.5 | INTEGER | RO | |
scalar · INTEGER · read-only · current The method used to delete old unused entries
refresh_flag:
The high level sets a flag when it adds or updates an entry,
the Switch clears the flag each time, when it learns the
station once more.
aging_flag:
The high level clears a flag when it adds or updates an entry,
the Switch sets the flag each time, when it learns the station
once more.
aging_time:
The high level defines a timeout, the Switch sends a message
to the high level each time when the station doesn't send
messages during interval between timeout and 2*timeout.
Boundaries:
The Switch doesn't support any mechanism, and the high level
uses two boundaries: red and yellow. When the number of entries
exceeds the red boundary, the high level deletes the oldest entries.
| ||||
| SrlBrgMacSwSpanningTree | 1.3.6.1.4.1.9.6.1.101.50.6 | INTEGER | RO | |
scalar · INTEGER · read-only · current Specifies whether the device supports port the Spanning Tree Protocol.
| ||||
| SrlBrgMacSwKeyType | 1.3.6.1.4.1.9.6.1.101.50.7 | INTEGER | RO | |
scalar · INTEGER · read-only · current Specified the used MAC Address Table kye format: macOnly: One global MAC Address Table per device (leaky VLANs). tagAndMac: MAC Address Table per each VLAN (strick VLANs).
| ||||
| SrlBrgMacSwYellowBoundary | 1.3.6.1.4.1.9.6.1.101.50.8 | INTEGER | RW | |
scalar · INTEGER · read-write · current The yellow boundary. | ||||
| SrlBrgMacSwRedBoundary | 1.3.6.1.4.1.9.6.1.101.50.9 | INTEGER | RW | |
scalar · INTEGER · read-write · current The yellow boundary. | ||||
| SrlBrgMacSwTrapEnable | 1.3.6.1.4.1.9.6.1.101.50.10 | TruthValue | RW | |
scalar · TruthValue · read-write · current This variable indicates whether to create a SNMP trap if adding dynamic mac failed due to full hash chain. | ||||
| SrlBrgMacSwOperTrapCount | 1.3.6.1.4.1.9.6.1.101.50.11 | INTEGER | RO | |
scalar · INTEGER · read-only · current This variable indicates the trap counter status (i.e. number of received MAC addresses since the last trap sent that haven't been inserted into the hash). It is relevant only when trap is enabled. | ||||
| SrlBrgMacSwAdminTrapFrequency | 1.3.6.1.4.1.9.6.1.101.50.12 | INTEGER (1..86400) | RW | |
scalar · INTEGER (1..86400) · read-write · current This variable indicates the minimal frequency (in seconds) of sending a trap. It is relevant only when trap is enabled. | ||||